Qi-Hardware Ben Nanonote reflashing
This are photos the steps to flash a dev version device of the Qi-Hardware Ben NanoNote, final version will have an already installed functional OS and surelly put the device in USB mode will be more smooth
I have followed this tutorials with no deviation so no sense to rewrite all commands again just some comments on the pictures, click on the image to view them on high resolution,.
Put Ben in USB BOOT mode
Developer version comes with a serie of items to test hardware
Removing rear battery department
Pulling out battery form NanoNote
With NanoNote switched off , plug the USB cable to your PC and Ben, be sure it not comes up again on plug the cable, if so press power button until it shutdown or unplug the cable and try again, and again, and againr ;P with practice you will cach the point
Then you have to short the USB BOOT contacts meanwhile you press the power button to put on the device.... I have tryed with a screedriver, a tap and cable but the most succesfull aproach whas my finger and a very tiny piece of alluminium tin foil.
If the screen remimains in black once you press the button for more than 2-3 seconds , congratulations you are in USB BOOT mode checkit with lsusb in the host.
Follow the How to reflash guide and next boot you will have a beatifull OpenWrt working
viewing packages installed
Enabling Ethernet over USB
Next running apps from Ben NanoNote photos :)